Specifications

3-190
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
show tacacs
show tacacs
To display TACACS+ authentication protocol configuration information for a WAAS device, use the
show tacacs EXEC command.
show tacacs
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values
Command Modes EXEC
Device Modes application-accelerator
central-manager
Examples Table 3-82 describes the fields shown in the show tacacs display.
Ta b l e 3-82 Field Descriptions for the show tacacs Command
Field Description
Login Authentication for
Console/Telnet Session
Indicates whether TACACS+ server is enabled for login
authentication.
Configuration Authentication for
Console/Telnet Session
Indicates whether TACACS+ server is enabled for
authorization or configuration authentication.
TACACS+ Configuration TACACS+ server parameters.
TACACS+ Authentication Indicates whether TACACS+ authentication is enabled on the
the WAAS device.
Key Secret key that the WAE uses to communicate with the
TACACS+ server. The maximum number of characters in the
TACACS+ key should not exceed 99 printable ASCII
characters (except tabs).
Timeout Number of seconds that the WAAS device waits for a
response from the specified TACACS+ authentication server
before declaring a timeout.
Retransmit Number of times that the WAAS device is to retransmit its
connection to the TACACS+ if the TACACS+ timeout
interval is exceeded.
Password type Mechanism for password authentication. By default, the
Password Authentication Protocol (PAP) is the mechanism
for password authentication.