Specifications
3-148
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
show standby
show standby
To display information about a standby interface on a WAAS device, use the show standby EXEC
command.
show standby
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines To display information about a specific standby group configuration, enter the show interface standby
standby group_num EXEC command.
Examples Table 3-64 describes the fields shown in the show standby display.
Ta b l e 3-64 Field Descriptions for the show standby Command
Field Description
Standby Group Number that identifies the standby group.
Description Description of the device, as configured by using the
description option of the interface global configuration
command.
IP address IP address of the standby group.
netmask Netmask of the standby group.
Member interfaces Member interfaces of the standby group. Shows which physical
interfaces are part of the standby group. Shows the interface
definition, such as GigabitEthernet 1/0.
priority Priority status of each interface.
Active interface Interfaces that are currently active in the standby group.
Maximum errors allowed on the
active interface
Maximum number of errors allowed on the active interface.