Specifications

3-141
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
show snmp
show snmp
To check the status of SNMP communications for a WAAS device, use the show snmp EXEC command.
show snmp {alarm-history | engine ID | event | group | stats | user}
Syntax Description
Defaults No default behavior or values
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines This EXEC command provides information on various SNMP variables and statistics on SNMP
operations.
Examples Table 3-55 describes the fields shown in the show snmp alarm-history display.
alarm-history Displays SNMP alarm history information.
engineID Displays local SNMP engine identifier.
event Displays events configured through the Event MIB.
group Displays SNMP groups.
stats Displays SNMP statistics.
user Displays SNMP users.
Ta b l e 3-55 Field Descriptions for the show snmp alarm-history Command
Field Description
Index Displays serial number of the listed alarms.
Type Indicates whether the alarm has been Raised (R) or Cleared (C).
Sev Levels of alarm severity: Critical (Cr), Major (Ma), or Minor (Mi)
Alarm ID Traps sent by a WAE contain numeric alarm IDs.
ModuleID Traps sent by a WAE contain numeric module IDs. (See the table below to map
module names to module IDs.)
Category Traps sent by a WAE contain numeric category IDs. (See the table below to
map category names to category IDs.)
Descr Provides description of the WAAS software alarm and the application that
generated the alarm.