Specifications

3-600
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
(config-if) no
mtu Set the interface Maximum Transmission Unit (MTU)
shutdown Shutdown the specific interface
standby Standby interface config commands
WAE(config-if)# no
However, if you are in Standby interface configuration mode, there are only four options for the no
command as shown in this example:
WAE(config)# interface standby 4
WAE(config-if)# no ?
description Standby interface description
errors Set the maximum number of errors allowed on this interface
ip Set the IP address of a standby group
shutdown Shutdown this interface
WAE(config-if)# no
Examples The following example shows how to configure the Gigabit Ethernet interface in slot 2, port 0 not to
autosense the interface bandwidth:
WAE(config)# interface GigabitEthernet 2/0
WAE(config-if)# no autosense
Related Commands (config) interface GigabitEthernet
show interface
show running-config
show startup-config