Specifications

3-586

Cisco Wide Area Application Services Command Reference

OL-16451-01

Chapter 3 CLI Commands

(config-if) encapsulation dot1Q

To set the VLAN ID that is to be assigned to traffic that leaves a WAE, use the encapsulation dot1Q

interface configuration command.

encapsulation dot1Q VLAN

Syntax Description

Defaults No default behavior or values.

Command Modes interface configuration

Device Modes application-accelerator

Usage Guidelines The encapsulation dot1Q command is available only for the inlineGroup interface.

Note If the VLAN ID that you set with the encapsulation dot1Q interface command does not match the

VLAN ID expected by the router subinterface, you may not be able to connect to the inline interface IP

address.

The inline adapter supports only a single VLAN ID for each inline group interface. If you have

configured a secondary address from a different subnet on an inline interface, you must have the same

secondary address assigned on the router subinterface for the VLAN.

Examples The following example shows how to set a VLAN ID to encapsulate traffic leaving the WAE:

(config)# interface inlineGroup 1/0

(config-if)# encapsulation dot1Q 100

Related Commands (config) interface GigabitEthernet

(config-if) ip

VLAN VLAN ID from 1–4094.