Specifications

3-580
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
Interface Configuration Mode Commands
To set, view, and test the configuration of WAAS software features on a specific interface, use the
interface global configuration command.
interface {GigabitEthernet slot/port | InlineGroup slot/group | PortChannel int_num | Standby
group_num}
Syntax Description
Defaults No default behavior or values.
Command Modes global configuration
Device Modes application-accelerator
Usage Guidelines Within interface configuration mode, you can use the interface commands (autosense, bandwidth, cdp,
etc.) to configure the specified interface.
To return to global configuration mode, use the exit command at the interface configuration mode
prompt.
Examples The following example shows how to enter interface configuration mode:
WAE(config)# interface gigabitethernet 1/0
WAE(config-if)#
Related Commands (config) interface InlineGroup
(config) interface PortChannel
(config) interface Standby
GigabitEthernet
slot/port
Selects a gigabit ethernet interface to configure.
InlineGroup slot/group Selects an inline group interface to configure.
PortChannel int_num Selects a port channel interface to configure.
Standby group_num Selects a standby group to configure.