Specifications

3-495

Cisco Wide Area Application Services Command Reference

OL-16451-01

Chapter 3 CLI Commands

(config) policy-engine application map other optimize DRE

To configure the optimize DRE action on nonclassified traffic on a WAE, use the policy-engine

application map other optimize DRE global configuration command.

policy-engine application map other optimize DRE {yes | no} compression {LZ | none}

[set-dscp dscp-marking]

Syntax Description

Command Modes global configuration

Device Modes application-accelerator

Usage Guidelines Use the policy-engine application map other optimize DRE global configuration command to

configure the optimize DRE action on nonclassified traffic on a WAE.

Note We strongly recommend that you use the WAAS Central Manager GUI to centrally configure application

policies for your WAEs. For more information, see the Cisco Wide Area Application Services

Configuration Guide.

Examples The following example shows how to configure the optimize DRE action on nonclassified traffic with

no compression:

WAE(config)# policy-engine application map other optimize DRE yes compression none

Related Commands (config) policy-engine application classifier

(config) policy-engine application map adaptor EPM

(config) policy-engine application map adaptor WAFS transport

(config) policy-engine application map basic

(config) policy-engine application map other optimize full

(config) policy-engine application map other pass-through

yes Applies the optimize DRE action on nonclassified traffic.

no Specifies not to apply the optimize DRE action on nonclassified traffic.

compression Applies the specified compression.

LZ Applies the Lempel-Ziv (LZ) compression.

none Applies no compression.

set-dscp dscp-marking (Optional) Sets the DSCP marking value (Table 3-119) to be applied to the

traffic classified in the policy.