Specifications

3-449
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
(config) flow monitor
(config) flow monitor
To enable network traffic flow monitoring and to register the WAE with the tcpstat-v1 collector for traffic
analysis, use the flow monitor global configuration command. To disable the network traffic flow
configuration, use the no form of this command.
flow monitor tcpstat-v1 {enable | host ip_address}
no flow monitor tcpstat-v1 {enable | host ip_address}
Syntax Description
Defaults The default configuration has no host address configured and the feature is disabled.
Command Modes global configuration
Device Modes application-accelerator
Usage Guidelines For information about how to configure flow monitoring on the WAE, see the Cisco Wide Area
Application Services Configuration Guide, Chapter 15.
For information about using the NetQoS SuperAgent console and configuring NetQoS SuperAgent
entities, go to the following website: http://www.netqos.com.
Examples The following example shows how to enable flow monitoring using the flow monitor command:
WAE(config)# flow monitor tcpstat-v1 enable
Related Commands debug flow
tcpstat-v1 Sets the tcpstat-v1 collector configuration.
enable Enables flow monitoring.
host ip_address Specifies the IP address of the collection control agent.