Specifications

3-339
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
show virtual-blade
show virtual-blade
To display virtual blade information on your WAE device, use the show virtual-blade EXEC command.
show virtual-blade [virtual-blade-number]
Syntax Description
Command Default No default behavior or values.
Command Modes EXEC
Device Modes application-accelerator
Examples The following is sample output from the show virtual-blade command. It displays general virtual blade
information.
WAAE# show virtual-blade
Virtual-blade resources:
VB Memory: 200MiB configured, 824MiB available.
VB Disk space: 4GiB configured, 117GiB available.
/local1/vbs: 128MiB used, 125644MiB available
CPU(s) assigned: 2
Virtual-blade(s) state:
virtual-blade 1 is stopped
The following is sample output from the show virtual-blade command. It displays information for a
specific virtual blade (virtual blade 1 in the example).
WAAE# show virtual-blade 1
virtual-blade 1
config:
description Windows 2003 Server
memory 200
disk 4
no boot fd-image
boot cd-image cd-rom
boot from cd-rom
interface 1 bridge GigabitEthernet 1/0 mac-address 00:16:3E:97:6F:84
device cpu qemu64
device nic rtl8139
device disk IDE
autostart
state:
stopped
Table 3-113 describes the fields shown in the show virtual-blade command display.
virtual-blade-number Specifies an individual virtual blade for which to view information.