Specifications

3-245
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
show statistics accelerator
Total Connections Handed-off Total Pushed Down Connections + Total Connections
Handed-off with Compression Policies Disabled.
Total Connections Handed-off with
Compression Policies Disabled
Total number of connections handed off to generic
optimization with compression policies disabled. This
statistic includes handoffs for SSL CONNECT requests
received by the HTTP Accelerator.
Total Fast Connections Total number of times a client side idle active WAN
connection was able to be reused instead of establishing
a new WAN connection.
Maximum Fast Connections on a Single
Connection
Maximum number of times a single connection was
reused. This is the “best case” of number of reuses on a
single connection.
Limited to be less than maximum session reuse count
(currently defined as 100 - an arbitrary max).
Percentage of connection time saved (Total Time Saved / (Total Time Saved + Total Round
Trip Time For All Connections)) * 100.
Total Round Trip Time for All Connections
(ms)
Total RTT for all WAN connections that have been
established.
Total Fast Connections Initiated by Peer Total number of times the server side WAN connection
was a fast connection initiated by the client side peer.
This statistic should match the Total Fast Connections on
the peer WAE.
Policy Engine Statistics
Session timeouts The number of times the accelerator application did not
issue a keepalive to the Policy Engine in a timely manner.
A session refers to the particular registration of the
accelerator application within the Policy Engine.
Total timeouts The total number of times the accelerator application did
not issue a keepalive to the Policy Engine in a timely
manner. This may encompass multiple registrations.
Last keepalive received The amount of time since the last keepalive (seconds).
Last registration occurred The amount of time since the accelerator application
registered with the Policy Engine (seconds). Most likely
causes are:
• WAE was rebooted
• Configuration change with the accelerator
application enabled
• Restart of the accelerator application by the Node
Manager
Hits Number of connections that had a configured policy
which specified the use of the accelerator application.
Table 3-72 Field Descriptions for the show statistics accelerator http Command (continued)
Field Description