Specifications

1-7
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 1 Using the WAAS Command-Line Interface
Using Command Modes
Using the Virtual Blade Configuration Mode
Use the virtual blade configuration mode to configure virtual blades within your WAE or WAVE device.
A WAAS virtual blade acts as a computer emulator with its own virtualized CPU, memory, firmware,
disk drive, CD drive, and network interface card. It works with your WAAS system to provide additional
services for the users on your network.
To enter this mode, use the virtual blade command from the global configuration mode.
To exit virtual blade configuration mode, use the exit command to return to global configuration mode:
WAE(config-vb)# exit
WAE(config)#
Command Modes Summary
Table 1-1 shows a summary of the WAAS command modes.
Table 1-1 WAAS Command Modes Summary
Command Mode Access Method Prompt Exit Method
user EXEC Log in to WAE.
WAE>
To exit, use the end command.
To enter privileged EXEC mode, use the
enable command.
privileged EXEC From user EXEC mode,
use the enable EXEC
command.
WAE#
To return to user EXEC mode, use the
disable command.
To enter global configuration mode, use
the configure command.
global configuration From privileged EXEC
mode, use the configure
command.
WAE(config)#
To return to privileged EXEC mode, use
the exit command or press Ctrl-Z.
To enter a configuration submode, use the
specific command related to the
submode.
interface configuration From global configuration
mode, use the interface
command.
WAE(config-if)#
To return to global configuration mode,
use the exit command.
To return to privileged EXEC mode, use
the end command or press Ctrl-Z.
standard ACL
configuration
From global configuration
mode, use the ip
access-list standard
command.
WAE(config-std-nacl)#
To return to global configuration mode,
use the exit command.
To return to privileged EXEC mode, use
the end command or press Ctrl-Z.
extended ACL
configuration
From global configuration
mode, use the ip
access-list extended
command.
WAE(config-ext-nacl)#
To return to global configuration mode,
use the exit command.
To return to privileged EXEC mode, use
the end command or press Ctrl-Z.