Specifications

3-176
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
show device-mode
show device-mode
To display the configured or current device mode of a WAAS device, use the show device-mode EXEC
command.
show device-mode {configured | current}
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines To display the configured device mode that has not yet taken effect, enter the show device-mode
configured EXEC command. For example, if you had entered the device mode central-manager global
configuration command on a WAAS device to change its device mode to central manager but have not
yet entered the copy run start EXEC command to save the running configuration on the device, then if
you were to enter the show device-mode configured command on the WAAS device, the command
output would indicate that the configured device mode is central-manager.
Examples The following is sample output from the show device mode command. It displays the current mode in
which the WAAS device is operating.
WAE# show device-mode current
Current device mode: application-accelerator
Table 3-29 describes the field in the show device-mode current command display.
The following is sample output from the show device configured command. It displays the configured
device mode that has not yet taken effect.
WAE# show device-mode configured
Configured device mode: central-manager
configured Displays the configured device mode, which has not taken effect yet.
current Displays the current device mode.
Table 3-29 Field Description for the show device-mode current Command
Field Description
Current device mode Current mode in which the WAAS device is operating.