Specifications

3-161
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
show cdp
show cdp
To display CDP configuration information, use the show cdp EXEC command.
show cdp entry neighbor [protocol | version [protocol]
show cdp holdtime | run | timer | traffic
show cdp interface [FastEthernet slot/port | GigabitEthernet slot/port]
show cdp neighbors [detail | FastEthernet slot/port [detail] | GigabitEthernet slot/port [detail]]
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines The show cdp command displays information about how frequently CDP packets are resent to
neighbors, the length of time that CDP packets are held by neighbors, the disabled status of CDP
Version 2 multicast advertisements, CDP Ethernet interface ports, and general CDP traffic information.
Examples Table 3-11 describes the fields shown in the show cdp command display.
entry neighbor (Optional) Displays information for a specific CDP neighbor entry.
protocol (Optional) Displays the CDP protocol information.
version (Optional) Displays the CDP version.
holdtime Displays the length of time that CDP information is held by neighbors.
run Displays the CDP process status.
timer Displays the time when CDP information is resent to neighbors.
traffic Displays CDP statistical information.
interface Displays interface status and configuration.
FastEthernet slot/port (Optional) Displays Fast Ethernet configuration (slot 0–3 and port number).
GigabitEthernet
slot/port
(Optional) Displays Gigabit Ethernet configuration (slot 1–2 and port
number).
neighbors Displays CDP neighbor entries.
detail (Optional) Displays detailed neighbor entry information.