Specifications

3-149
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
show accelerator
show accelerator
To display the status and configuration of the application accelerators, use the show accelerator EXEC
command.
show accelerator [{cifs | detail | epm | http | mapi | nfs | video}]
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Device Modes application-accelerator
Examples Table 3-2 describes the fields shown in the show accelerator command display for all application
accelerators. Specific application accelerators display additional configuration status information.
cifs (Optional) Displays the status for the CIFS application accelerator.
detail Displays the license information, enables the configuration state and
operation state for all accelerators, and additional accelerator and policy
engine configuration.
epm (Optional) Displays the status for the EPM application accelerator.
http (Optional) Displays the status for the HTTP application accelerator.
mapi (Optional) Displays the status for the MAPI application accelerator.
nfs (Optional) Displays the status for the NFS application accelerator.
video (Optional) Displays the status for the video application accelerator.
Table 3-2 Field Description for the show accelerator Command
Field Description
Accelerator Name of the accelerator.
Licensed Yes or No.
Config State Accelerator is Enabled or Disabled.
Operational State Shutdown, Initializing, Running, Cleaning Up, or Expired
License.
Policy Engine Config Item: State Registered (policy engine is communicating with the
accelerator) or Not Registered (policy engine is not
communicating with the accelerator; seen when the accelerator
is disabled).
Policy Engine Config Item: Default
Action
Drop or Use. Default policy action specifies whether the TFO
action is configured for mapping (Use Policy), or the SYN
should be dropped.