Specifications

D14330.06 ADMINISTRATOR GUIDE TANDBERG E20—July 2009
33
What’s in this Guide? Introduction Getting Started Using E20 The Settings Advanced settings
Advanced Settings
Standby
The Standby Control setting determines whether the system should go
into standby mode or not.
Control On: The system will go into standby mode when the
Standby Delay has timed out. Requires the Standby Delay to be set
to an appropriate value.
Control Off: The system will not go into standby.
Delay: Defines how long (in minutes) the system will wait before
it goes into standby mode. Requires the Standby Control to be
enabled. Range 1–480 minutes.
System Unit
Enter a System Name to define a name of the system unit. The system
name will be displayed when the E20 is acting as an SNMP Agent and
towards a DHCP server.
HearingImpairedMode
On: If this setting is on, the device will play a blinking, orange video
whenever there is an incoming call.
Off: Default
MenuLanguage
This setting allows you to set the menu language, if necessary.
Name
Readable name of the device, e.g. Joe’s E20
Time
Allows you to set the time zone accordingly.
Video
Set the Selfview to On or Off. Selfview is the outgoing video (what the
others see) from your E20.
Change password
This allows you to change the administrator password on the device. This
is done by entering the password in the password field and pressing the
Save button. The User can cancel the password update by pressing the
Cancel button.
Restart
Use this to reboot the E20 in a controlled manner.