User guide

CaseViewNet Linksys E1200 Router Guide

Configure the Router

To configure the Linksys E1200 router:

1. Disable the built-in WiFi, wireless capability, on your computer. A switch or access to your computer

vendor's application may be required. If Windows

does not manage the wireless networking on your

computer, a message displays. For additional information, refer to the user guide for your computer

or contact the computer manufacturer.

2. Plug the Linksys wireless router power cord into a wall outlet or power strip and then plug the other

end of the power cord into the router. The router is on when the I/O indicator light on the back

displays a steady green.

3. Locate the network cable, packaged with the Linksys wireless router. Plug one end of the network

cable into Ethernet 1 (blue) port of the router and plug the other end of the network cable into your

network port or NIC card on your computer.

4. Open your Internet browser. In a few seconds, a message displays indicating that Internet Explorer

cannot display the web page. Depending on the Browser being used, the appearance of the page

may be different.

5. In the Address line of your Internet browser, type the following: 192.168.1.1 and click Go, , or

press Enter.