User guide

CaseViewNet Linksys E1200 Router Guide
26
© 2012 Stenograph, L.L.C.
Case CATalyst Setup for CaseViewNet
1. Plug in your configured router. Verify the router is On before proceeding. The router is on when the
I/O indicator on the back displays a steady green.
2. Turn on your Case CATalyst computer and wait until it is fully booted.
3. Verify the wireless capability on your computer is enabled.
4. Connect to the wireless network you are using with CaseViewNet. This is the network identified
during the router configuration. If you chose a security mode and assigned a passphrase during
router configuration, it is necessary to type the passphrase the first time you connect to your wireless
network. After your first connection, Windows automatically connects to your wireless network if it
was the last network connected to on this computer, the wireless network is set as default or if it is
the only available network in range.
To manually connect to the network, do one of the following.
• Windows 7 - Click the wireless icon in the Sys Tray and select your wireless network. Click
Connect. Type the passphrase if prompted.
• Windows Vista
- Right click the wireless icon in the SysTray and Connect to a network from the
menu. Select your wireless network, type the passphrase if prompted and click Connect.
• Windows XP - Right click the wireless icon in the SysTray and select View Available Wireless
Networks from the menu. Select your wireless network, type the passphrase if prompted and
click Connect.
A switch or access to your computer vendor's WiFi application may be required. If Windows does not
manage the wireless networking on your computer, a message displays. For additional information,
refer to the user guide for your computer or contact the computer manufacturer.
5. Start Case CATalyst version 8.20 or higher.
6. Select Function/Translate & Edit. The Translate dialog box displays.
7. In the Output To field, select CaseView.
8. Click Options. The Translate Options dialog box displays.
9. Select the Output to CaseView tab.
10. In the Output over comm port field, verify the box is unchecked.
If you are sending to both CaseViewNet and a serial compatible software, such as CaseView II,
check this box and make necessary CaseView II Options entries. See the Case CATalyst Help for
additional information about CaseView II.