Operation Manual

Chapter 2 Installing the Wireless Gateway
18 TP-00100
6 Locate the AC power cord provided with your Wireless Gateway. Connect the
barrel connector end of the power cord into the power input on the back of the
Wireless Gateway. Then, plug the other end of the power cord into an AC outlet.
The Wireless Gateway will perform an automatic search to locate and sign on to
the broadband data network. This process may take up to 2-5 minutes. The
Wireless Gateway will be ready for use when the P owe r , US/DS, and Online
LEDs on the front panel of the Wireless Gateway stop blinking and remain on
continuously.
7 Plug in and power on your PC and other home network devices. If one or more
of these devices uses wireless networking, the 2.4 GHz or 5 GHz LED on the
Wireless Gateway should be on or blinking.
8 At this point, the installation is complete, and you can begin surfing the Internet.
Note: If your PC does not have Internet access, refer to How Do I Configure
TCP/IP Protocol? (on page 48) for information on how to configure your PC for
TCP/IP. For Internet devices other than PCs, refer to the DHCP or IP Address
configuration section of the User Guide or Operations Manual for those devices.