User guide

5
1 POWER
Connects the cable modem to the AC power adapter that
is provided with your cable modem
2 Ethernet
One RJ-45 Ethernet port connects to the Ethernet port on your
PC or your home network
3 Reset
A momentary pressing (1-2 seconds) of this switch causes
a reset-to-factory default of all settings and then reboots the cable modem
(To be used ONLY if instructed by the NWT Service Desk)
4 MAC ID Displays the MAC address of the modem
5 Cable
F-connector connects to an active cable signal
from your service provider
1 Power No power It never flashes Power is on
2 DS
Receive channel
not found
Scanning for a
receive channel
Connected to a
receive channel
3 US
Send channel
not found
Scanning for
a send channel
Connected to
a send channel
4 Online
Internet connection
failed
Scanning for a
network connection
Online and the
startup process
is complete
5 Link
No connection
to modem Ethernet
port detected
Sending and/or
receiving data
Connected to
a computer
Rear Panel – 3008
Front Panel - 3008
Cisco DPC 3008 Cable Modem
Key Port Description
Key Light Off Flashing On