Specifications

1-51
Cisco ONS 15454 Installation and Operations Guide, R3.2
January 2005
Chapter 1 Hardware Installation
Card Installation
Figure 1-30 Installing a GBIC on an E1000-2 card
Step 4
Slide the GBIC through the cover flap until you hear a click.
The click indicates the GBIC is locked into the slot.
Warning
GBICs are Class I laser products. These products have been tested and comply with Class I limits.
Warning
Invisible laser radiation may be emitted from the aperture ports of the single-mode fiber optic
modules when no cable is connected. Avoid exposure and do not stare into open apertures.
Step 5 When you are ready to attach the network interface fiber-optic cable, remove the plug from the GBIC
and save the plug for future use.
Step 6 Install and route the cable. See the “Optical Cable Management” section on page 1-55 for routing
instructions.
E1000
2
FAIL
ACT
1
SF
33678 12931
2
RX
TX
RX
TX
ACT/LINK
ACT/LINK
44734
Plug