Specifications

9-35
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 9 Ethernet Operation
G1000-4 Circuit Configurations
Figure 9-28 Circuit Creation (Circuit Source) dialog box
Step 8
Choose the circuit source node from the Node menu.
Step 9 From the Slot menu choose the slot containing the Ethernet card.
Step 10 From the Port menu choose a port.
Step 11 Click Next.
The Circuit Creation (Destination) dialog box opens.
Step 12 From the Node menu, choose the current node as the circuit destination.
Step 13 From the Slot menu, choose the optical card that will carry the circuit.
Step 14 Choose the STS that will carry the circuit from the STS menu and click Next.
Note For Ethernet manual cross-connects, the same ONS 15454 serves as both source and destination.
Step 15 Confirm that the following information is correct:
• Circuit name
• Circuit type
• Circuit size
• ONS 15454 nodes included in this circuit
Note If the circuit information is not correct use the Back button, then redo the procedure with the
correct information. Alternately, you can click Finish, then delete the completed circuit and start
the procedure from the beginning.
Step 16 Click Finish.
Step 17 You now need to provision the Ethernet ports. For port provisioning instructions, see the “Provision
G1000-4 Ethernet Ports” procedure on page 9-7.
Step 18 To complete the procedure, repeat Steps 1 – 16 at the second ONS 15454.
Note The appropriate STS circuit must exist in the non-ONS 15454 equipment to connect the two STSs from
the ONS 15454 Ethernet manual cross-connect endpoints.