Specifications

9-32
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 9 Ethernet Operation
G1000-4 Circuit Configurations
Step 2 In CTC node view, click the Circuits tab and click Create.
The Circuit Creation (Circuit Attributes) dialog box opens. (Figure 9-25)
Figure 9-25 Creating a G1000-4 circuit
Step 3
In the Name field, type a name for the circuit.
Step 4 From the Type pull-down menu, choose STS.
The VT and VT Tunnel types do not apply to Ethernet circuits.
Step 5 Choose the size of the circuit from the Size pull-down menu.
The valid circuit sizes for a G1000-4 circuit are STS-1, STS-3c, STS-6c, STS-9c, STS-12c, STS-24c,
and STS-48c.
Step 6 Verify that the Bidirectional checkbox is checked and click Next.
Note Users can ignore the Number of Circuits box and the Protected Drops box.
Caution If you are provisioning a G1000-4 circuit on a UPSR do not check the Switch on PDI-P box. Checking
the Switch on PDI-P box may cause unnecessary UPSR protection switches.
The Circuit Creation (Circuit Source) dialog box opens (Figure 9-26).