Specifications

9-18
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 9 Ethernet Operation
E Series Circuit Configurations
• Circuit name
• Circuit type
• Circuit size
• VLANs on the circuit
• ONS 15454 nodes included in the circuit
Step 21 Click Finish.
Step 22 You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning
instructions, see the “Provision E Series Ethernet Ports” procedure on page 9-11. For assigning ports to
VLANs, see the “Provision Ethernet Ports for VLAN Membership” procedure on page 9-39. For
information about manually provisioning circuits, see the “E Series Ethernet Manual Cross-Connects”
procedure on page 9-25.
9.4.3 E Series Shared Packet Ring Ethernet Circuits
This section provides steps for creating a shared packet ring (Figure 9-13). Your network architecture
may differ from the example.
Figure 9-13 A shared packet ring Ethernet circuit
Procedure: Provision an E Series Shared Packet Ring
Step 1 Display CTC for one of the ONS 15454 Ethernet circuit endpoints.
Step 2 Double-click one of the Ethernet cards that will carry the circuit.
Step 3 Click the Provisioning > Card tabs.
ONS NodeONS Node
Access router
Backbone router
Access router
Access router
Access router
SONET/SDH Ring
Access router Access router
ONS Node
32165
SONET
Ethernet