Specifications

9-16
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 9 Ethernet Operation
E Series Circuit Configurations
Figure 9-11 A Single-card Etherswitch point-to-point circuit
Procedure: Provision an E Series EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)
Step 1 Display CTC for one of the ONS 15454 Ethernet circuit endpoint nodes.
Step 2 Double-click one of the Ethernet cards that will carry the circuit.
Step 3 Click the Provisioning > Card tabs.
Step 4 If you are building a Multicard Etherswitch point-to-point circuit:
a. Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
b. If Multi-card EtherSwitch Group is not checked, check it and click Apply.
c. Repeat Steps 2 – 4 for all other Ethernet cards in the ONS 15454 that will carry the circuit.
If you are building a Single-card Etherswitch circuit:
d. Under Card Mode, verify that Single-card EtherSwitch is checked.
e. If Single-card EtherSwitch is not checked, check it and click Apply.
Step 5 Navigate to the other ONS 15454 Ethernet circuit endpoint.
Step 6 Repeat Steps 2 – 5.
Step 7 Click the Circuits tab and click Create.
The Circuit Creation (Circuit Attributes) dialog box opens.
Step 8 In the Name field, type a name for the circuit.
Step 9 From the Type pull-down menu, choose STS.
Note The VT and VT Tunnel types do not apply to Ethernet circuits.
Step 10 Choose the size of the circuit from the Size pull-down menu.
The valid circuit sizes for an Ethernet Multicard circuit are STS-1, STS-3c and STS-6c.
The valid circuit sizes for an Ethernet Single-card circuit are STS-1, STS-3c, STS-6c and STS-12c.
Step 11 Verify that the Bidirectional checkbox is checked and click Next.
ONS 15454 3ONS 15454 2
ONS 15454 1
192.168.1.50
255.255.255.0
VLAN test
Slot 15
192.168.1.25
255.255.255.0
VLAN test
Slot 4
32161