Specifications

8-46
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 8 Performance Monitoring
Performance Monitoring for Optical Cards
8.6.3 OC-48 and OC-192 Card Performance Monitoring Parameters
Figure 8-22 shows the signal types that support far-end PMs. Figure 8-23 shows where overhead bytes
detected on the ASICs produce performance monitoring parameters for the OC-48 and OC-192 cards.
Figure 8-24 Monitored signal types for the OC-48 and OC-192 cards
Note PMs on the protect STS are not supported for BLSR. The XX in the illustration above represents all
PMs listed below with the given prefix and/or suffix.
Figure 8-25 PM read points on the OC-48 and OC-192 cards
Note For PM locations relating to protection switch counts, see the GR-1230-CORE document.
55313
ONS 15454
DS1 OC-N
Fiber
Near End
OC-N Signal
STS Path (STS XX-P) Far End PMs Not Supported
ONS 15454
DS1OC-N
Far End
OC-N Signal
ONS 15454
OC-N Card
BTC ASIC
XC10G Card DS1
CV-S
ES-S
SES-S
SEFS-S
CV-L
ES-L
SES-L
UAS-L
FC-L
PPJC-Pdet
NPJC-Pdet
PPJC-Pgen
NPJC-Pgen
STS CV-P
STS ES-P
STS FC-P
STS SES-P
STS UAS-P
PMs read on BTC ASIC
Note: The OC-48 and OC-192 have 1 port per card.
61119