Specifications

Procedures
xxxi
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Set Up Internal Timing 3-16
IP Networking
Create a Static Route 4-8
Set up OSPF 4-12
SONET Topologies
Install the BLSR Trunk Cards 5-11
Create the BLSR DCC Terminations 5-13
Enable the BLSR Ports 5-13
Remap the K3 Byte 5-14
Provision the BLSR 5-15
Upgrade From a Two-Fiber to a Four-Fiber BLSR 5-17
Add a BLSR Node 5-19
Remove a BLSR Node 5-22
Move a BLSR Trunk Card 5-25
Install the UPSR Trunk Cards 5-31
Configure the UPSR DCC Terminations 5-32
Enable the UPSR Ports 5-33
Switch UPSR Traffic 5-33
Add a UPSR Node 5-35
Remove a UPSR Node 5-36
Subtend a UPSR from a BLSR 5-39
Subtend a BLSR from a UPSR 5-39
Subtend a BLSR from a BLSR 5-41
Create a Linear ADM 5-43
Convert a Linear ADM to UPSR 5-43
Convert a Linear ADM to a BLSR 5-48
Circuits and Tunnels
Create an Automatically Routed Circuit 6-2
Create a Manually Routed Circuit 6-6
Create a Unidirectional Circuit with Multiple Drops 6-8
Create a Monitor Circuit 6-9
Search for ONS 15454 Circuits 6-10
Edit a UPSR Circuit 6-11