Specifications

8-14
Cisco ONS 15454 Installation and Operations Guide, R3.2
March 2002
Chapter 8 Performance Monitoring
Performance Monitoring for Electrical Cards
Step 2 From the card view, click the Provisioning > Line tabs.
Step 3 Click the PJStsMon# menu and select a number.
• The value of 0 means pointer justification monitoring is disabled.
• The values 1-N are the STS numbers on one port. One STS per port can be enabled from the
PJStsMon# menu.
EC1 PJStsMon# card menu: 0 or 1 can be selected on a total of 12 ports.
OC-3 PJStsMon# card menu: 1, 2, or 3 can be selected on a total of 4 ports.
OC-12 PJStsMon# card menu: 1 or any number through 12 can be selected on 1 port.
OC-48 PJStsMon# card menu: 1 or any number through 48 can be selected on 1 port.
OC-192 PJStsMon# card menu: 1 or any number through 192 can be selected on 1 port.
Step 4 Click Apply and return to the Performance tab to view PM parameters.
8.5 Performance Monitoring for Electrical Cards
The following sections define performance monitoring parameters for the EC1, DS1, DS1N, DS3,
DS3N, DS3-12E, DS3N-12E, and DS3XM electrical cards.
8.5.1 EC1 Card Performance Monitoring Parameters
Figure 8-11 shows signal types that support far-end PMs. Far-end performance monitoring is not
reported for EC1. Figure 8-12 shows where overhead bytes detected on the application specific
integrated circuits (ASICs) produce performance monitoring parameters for the EC1 card.
OC48 LR 1550 OC48 IR/STM16 SH AS 1310
OC48 LR/STM16 LH AS 1550 OC48 ELR/STM16 EH 100 GHz
OC48 ELR/STM16 EH 200 GHz OC192 LR/STM64 LH 1550
Table 8-4 Traffic Cards that Terminate the Line, Called LTEs (continued)
Line Terminating Equipment