User guide

PTP 800 Series User Guide Antennas and couplers
phn-2513_004v000 (Oct 2012)
1-33
Further reading on antennas and couplers
For more information on antennas and antenna accessories, refer to the following:
• Site selection on page 2-3 describes how to select a site for the antenna.
• Grounding and lightning protection on page 2-7 describes the grounding and lightning
protection requirements of a PTP 800 installation, including the antenna.
• Ordering antennas on page 2-59 lists the antennas required for PTP 800 installations,
with Cambium part numbers.
• Ordering RMKs and waveguides on page 2-85 lists the RMKs, waveguides, hangers and
transitions required for PTP 800 installations, with Cambium part numbers.
• Ordering coupler mounting kits on page 2-88 lists the couplers required for PTP 800
installations, with Cambium part numbers.
• Ordering OMKs on page 2-90 lists the OMKs required for PTP 800 installations, with
Cambium part numbers.
• Equipment specifications on page 4-2 contains specifications of the flexible
waveguides and couplers.
• Installing antennas and ODUs on page 5-5 describes how to install the antennas, ODUs
and waveguide connections at each link end, either in a direct mount or remote mount
configuration, with or without couplers.
• Task 12: Aligning antennas on page 6-98 describes how to align the two antenna in a
link.