User guide

PTP 800 Series User Guide Managing performance
phn-2513_004v000 (Oct 2012)
7-63
Figure 196 Diagnostics page (1+1 link)
Using the diagnostics plotter
The diagnostics plotter can trace the following statistics (refer to Table 261 for
definitions):
• Vector Error
• Rx Power
• Tx Power
• Link Loss
• Rx Data Rate
• Tx Data Rate
• Aggregate Data Rate
• Protection State: In a 1+1 Hot Standby configuration, only one CMU / RFU at a given
end of the link is Active at any one time, the neighbor CMU / RFU being Inactive. The
Protection State indicates whether a CMU / RFU is in the Active or Inactive state.
• Remote Primary Secondary Mode: This indicates the Primary /Secondary Mode of the
active unit at the remote end of the wireless link.