User guide

Managing alarms and events Chapter 7: Operation
7-18
phn-2513_004v000 (Oct 2012)
Fips Operational Mode Alarm
Definition: The unit is FIPS 140-2 capable, but has not been configured correctly for FIPS
140-2 operation.
Cause and action:
• ‘FIPS mode is not configured’: The Security Wizard has not been completed.
• ‘FIPS mode is configured, but not active’: The Security Wizard has been completed, but
the HTTP and Telnet management interfaces have not been disabled.
Licensed Transmit Capacity Status
Definition: In a 1+1 Hot Standby configuration, this indicates that the Licensed Transmit
Capacity is below that of its neighbor.
Cause and action: This is probably due to a configuration error or the wrong license
being applied to one of the CMUs.
Link name mismatch
Definition: The link names at each end of the wireless link do not match.
Cause and action: The link name is configured differently at each end of the wireless
link. This may be because of:
• A configuration error in defining the link name at one of the PTP 800s, see Step 1:
Enter equipment details on page 6-65;
• This unit is aligned to the wrong link partner.
Management port configuration mismatch
Definition: The Ethernet configuration of the management port is not compatible with the
connected network equipment.
Cause and action: This is probably due to a configuration error such as an auto-
negotiation or forced configuration mismatch. See Configuring the IP interface and
management mode on page 6-10.
Management port disabled warning
Definition: The management port has been disabled by means of the SNMP MIB.
Cause and action: The port has been disabled by a network management system. The
web browser provides no means of disabling this port.