User guide

PTP 800 Series User Guide Task 11: Configuring remote access
phn-2513_004v000 (Oct 2012)
6-97
Table 244 Web-Based Management attributes
Attribute Meaning
HTTPS Access
Enabled
Only displayed when HTTPS is configured. Shows the current
status of HTTPS access (enabled or not).
HTTPS Port
Number
Only displayed when HTTPS is configured. The port number for
HTTPS access. A value of zero means the wireless unit uses the
default port.
HTTP Access
Enabled
‘No’ means that the unit will not respond to any requests on the
HTTP port.
‘Yes’ means that the unit will respond to requests on the HTTP
port.
HTTP Port
Number
The port number for HTTP access. A value of zero means the
wireless unit uses the default port.
Telnet Access
Enabled
‘No’ means that the unit will not respond to any requests on the
Telnet port.
‘Yes’ means that the unit will respond to requests on the Telnet
port.
Telnet Port
Number
The port number for Telnet access. A value of zero means the
wireless unit uses the default port.
Access Control ‘Enabled’ means that web-based management can be access by
IP address. Up to three IP addresses may be entered.
SNMP Control of
HTTP And Telnet
‘Disabled’ means that neither HTTP nor Telnet can be controlled
remotely via SNMP.
‘Enabled’ means that both HTTP and Telnet can be controlled
remotely via SNMP.
TFTP Client ‘Disabled’ means that the unit will not respond to any TFTP
software download requests.
‘Enabled’ means that software can be downloaded via TFTP, as
described in Upgrading software on page 7-68.
Debug Access
Enabled
‘Yes’ means that Cambium Technical Support is allowed to
access the system to investigate faults.
Cross Site Request
Forgery Protection
‘Enabled’ means that Cross Site Request Forgery Protection is
enabled.