User guide

Task 8: Setting up SNMP agent Chapter 6: Configuration and alignment
6-86
phn-2513_004v000 (Oct 2012)
Configuring SNMPv1/2c agent
Perform this task to enable the system to generate Simple Network Management Protocol
version 1 or 2c (SNMPv1 or SNMPv2c) traps.
Start SNMP wizard
To start the SNMP wizard, select menu option Management, SNMP. The Current SNMP
Summary page is displayed (Figure 152). Review the summary. If any updates are
required, select Continue to SNMP Wizard.
Step 1: SNMP Configuration (for SNMPv1/2c)
The Step 1: SNMP Configuration page is displayed. Set SNMP State to ‘Enabled’ and set
SNMP Version to ‘v1/2c’. The page is redisplayed with SNMPv1/2c attributes (Figure 159).
Update the attributes (Table 240), then select Next.
Figure 159 Step 1: SNMP Configuration page (for SNMPv1/2c)
Table 240 Step 1: SNMP Configuration attributes (for SNMPv1/2c)
Attribute Meaning
SNMP State ‘Enabled’ means that the system will generate SNMP traps.
SNMP Access
Control
‘Enabled’ means that access to SNMP is controlled via IP
address. Up to three IP addresses may be entered.
SNMP Version SNMP protocol version v1/2c or v3.