User guide

PTP 800 Series User Guide Task 8: Setting up SNMP agent
phn-2513_004v000 (Oct 2012)
6-77
Task 8: Setting up SNMP agent
If SNMP is enabled, when an event occurs, the SNMP agent on the unit sends a trap to
whatever SNMP trap receivers have been configured.
Depending upon which SNMP version is required, choose one of the following procedures:
• Configuring SNMPv3 agent on page 6-77
• Configuring SNMPv1/2c agent on page 6-86
Configuring SNMPv3 agent
Perform this task to enable the system to generate Simple Network Management Protocol
version 3 (SNMPv3) traps.
Starting SNMP wizard
To start the SNMP wizard, select menu option Management, SNMP. The Current SNMP
Summary page is displayed (Figure 152). Review the summary. If any updates are
required, select Continue to SNMP Wizard.
Figure 152 Current SNMP Summary page (when SNMP is disabled)