User guide

Task 7: Configuring wireless interface Chapter 6: Configuration and alignment
6-72
phn-2513_004v000 (Oct 2012)
Step 3: Configuring wireless parameters
Step 3 of the Installation Wizard is for updating the constraints on wireless operation
(Figure 147 or Figure 148). The attributes are described in Table 234. Update the
attributes as required and select Next.
Figure 147 Step 3: Wireless Configuration page (normal)
Figure 148 Step 3: Wireless Configuration page (ETSI adaptive modulation)
Table 234 Step 3: Wireless Configuration attributes
Attribute Meaning
Maximum Transmit
Power
The maximum transmit power the wireless unit is permitted
to use when establishing and maintaining the wireless link.
This defaults to the lowest of the maximum allowed by the
equipment, the maximum allowed by the license or the user
maximum set in a previous installation.
When an IRFU is connected (rather than an ODU), this
refers to the power at the transceiver output, not at the
antenna port.
EIRP EIRP that is achieved when the transmitter is operating at
the configured Maximum Transmit Power.