User guide

PTP 800 Series User Guide Task 7: Configuring wireless interface
phn-2513_004v000 (Oct 2012)
6-63
Task 7: Configuring wireless interface
The Installation Wizard handles the important configuration settings that must be set to
comply with the individual license conditions. These settings can only be changed using
the Installation Wizard.
This task consists of the following procedures:
• Prerequisites for the Installation Wizard on page 6-63
• Step 1: Enter equipment details on page 6-65
• Step 2: Enter details of the radio license on page 6-69
• Step 3: Configuring wireless parameters on page 6-72
• Step 4: Confirming installation configuration on page 6-73
• Step 5: Skipping antenna alignment on page 6-75
• Step 6: Completing configuration without alignment on page 6-76
Prerequisites for the Installation Wizard
Before performing Steps 1 to 4 of the Installation Wizard, check that the following are
available:
• All license details, including maximum EIRP, antenna gain, transmit and receive
frequencies, channel bandwidth.
• A unique link name for this link.
Link Name must be the same at both link ends, otherwise the link will not work.
Starting Installation Wizard
To start the Installation Wizard, select menu option Installation. The Current Installation
Summary page (Figure 141) is displayed. Review the summary. To make any changes,
select Continue to Installation Wizard.