User guide

PTP 800 Series User Guide Task 2: Configuring IP and Ethernet interfaces
phn-2513_004v000 (Oct 2012)
6-15
Attribute Meaning
Management Port Auto
Neg Advertisement
Select the data rate that the auto-negotiation mechanism will
advertise as available on the out-of-band management
Ethernet interface. Use the same setting for both ends of the
link.
Ensure that this attribute has the same setting in the CMU
and in connected network equipment. If they are not
consistent, then a duplex mismatch will occur, resulting in
greatly reduced data capacity.
Only select a data rate that is within the capability of
connected network equipment, otherwise loss of service
may occur.