User guide

PTP 800 Series User Guide
phn-2513_004v000 (Oct 2012)
6-1
Chapter 6: Configuration and alignment
This chapter describes how to configure a PTP 800 link and align its antennas.
Observe the precautions in Preparing for configuration and alignment on page 6-2.
Configure the two units by performing the following tasks:
• Task 1: Connecting to the unit on page 6-3
• Task 2: Configuring IP and Ethernet interfaces on page 6-8
• Task 3: Installing license keys on page 6-21
• Task 4: Upgrading software version on page 6-25
• Task 5: Configuring security on page 6-28
• Task 6: Configuring protection on page 6-53
• Task 7: Configuring wireless interface on page 6-63
• Task 8: Setting up SNMP agent on page 6-77
• Task 9: Configuring alarms and messages on page 6-90
• Task 10: Configuring syslog on page 6-94
• Task 11: Configuring remote access on page 6-96
When all equipment has been installed at both link ends, perform the following tasks:
• Task 12: Aligning antennas on page 6-98
• Task 13: Reviewing configuration and performance on page 6-106
• Task 14: Configuring quality of service on page 6-111
• Task 15: Connecting link to the network on page 6-114
If FIPS 140-2 secure mode is required, refer to Configuring for FIPS 140-2 applications
on page 6-121.
For 1+1 Hot Standby links, configure all four units and align all antennas.