User guide

PTP 800 Series User Guide Installing antennas and ODUs
phn-2513_004v000 (Oct 2012)
5-5
Installing antennas and ODUs
Applies to ODU deployments only.
This section describes how to install the antennas, ODUs and waveguide connections at
each link end.
Use Table 214 to select installation procedures.
Table 214 Selecting antenna and ODU installation procedures
Hardware
configuration
Antenna
mounting
Antenna
protection?
Procedures to be performed
1+0 Direct - Installing a direct mount antenna with
one ODU on page 5-6.
1+0 Remote - Installing a remote mount antenna with
one ODU on page 5-9.
1+1 Direct No Installing a direct mount antenna with
two ODUs (via coupler) on page 5-20.
1+1 Direct Yes Installing a direct mount antenna with
one ODU on page 5-6. Repeat for the
second antenna and ODU.
1+1 Remote No Installing a remote mount antenna with
two ODUs (via coupler) on page 5-26.
1+1 Remote Yes Installing a remote mount antenna with
one ODU on page 5-9. Repeat for the
second antenna and ODU.
2+0 co-polar Direct - Installing a direct mount antenna with
two ODUs (via coupler) on page 5-20.
2+0 co-polar Remote - Installing a remote mount antenna with
two ODUs (via coupler) on page 5-26.
2+0 cross-polar Direct - Installing a direct mount dual-polar
antenna with two ODUs on page 5-33.
2+0 cross-polar Remote - Installing a remote mount antenna with
one ODU on page 5-9. Install two ODUs
and waveguides and one dual-polar
antenna, but connect both ODUs to the
antenna via the waveguide ports.