User guide

PTP 800 Series User Guide Preparing for installation
phn-2513_004v000 (Oct 2012)
5-3
Preparing personnel
In no event shall Cambium Networks be liable for any injury or damage caused during the
installation of the Cambium PTP 800.
Ensure that only qualified personnel undertake the installation of a PTP 800 link.
Ensure that all safety precautions are observed.
Preparing inventory
Perform the following inventory checks:
• Check that an installation report is available and that it is based on the principles
described in Chapter 2: Planning considerations.
• Check that the correct components are available, as described Ordering components
on page 2-57.
• Check the contents of all packages against their packing lists.
Preparing tools
Check that the tools listed in Table 213 are available.
Table 213 Tools required for PTP 800 installation
Equipment to be Installed Tools Required
CMU Pozi screw driver (PZ1)
Ground lug crimp tool (diameter 5mm)
8mm spanner
Direct Mount ODU Lubricant (supplied)
Remote Mount 17mm spanner
Lubricant (supplied)
Flexible Wave Guide Allen key (supplied in the kit)
Flexible Wave Guide hanger 13mm spanner
5mm Allen key
Flat bladed screw driver (6mm) or
Pozi screw driver (PZ2)