Programming instructions

89
Software Procedures
To program the IP address that IMAT will access:
1. Program the PC’s serial port with a baud rate of 38400.
2. Connect the IMAT PC to the NSU serial port.
3. Establish a terminal session with the NSU card.
4. Reboot the NSU.
5. Press any key during auto-boot to halt the boot process.
6. At the [MC269AA Boot]-: prompt enter C.
7. Change the boot parameters, inet on ethernet (e) :
192.168.1.1:ffffff00 and for gateway inet (g) : 192.168.1.251 default
values to the values provided to you by your LAN administrator.
8. For all other settings, press ENTER to accept the default.
9. At [VXWorks Boot], type @, or press the Reset button on the
controller.
10. Connect the NSU Ethernet port to the LAN.
Dial-up Connection of the IMAT PC to the NSU
For Windows 95 and Windows 98, refer to "Connect a Windows 95/98 PC
to the NSU via Dial-Up" on page 90.
For Windows 4.0, Windows 2000 Professional, or Windows XP without a
NIC, refer to IMAT Online Help for Dial-up connection details.