Programming instructions

88
3300 ICP Technician’s Handbook
Install and Use IMAT
The ISDN Maintenance and Administration Tool (IMAT) software is used
to program PRI and R2 cards and Network Services Units. IMAT is also
used to install PRI card and R2 card software.
Installing IMAT on the PC
You can install IMAT on the Maintenance PC or on its own PC (IMAT PC).
To install IMAT on the PC:
1. Close all the applications running on the PC.
2. Insert the 3300 ICP software CD-ROM in the CD drive.
3. Open the Tools folder, then the Disk 1 folder.
4. Double click the Setup.exe file. The installation program starts. Follow
the prompts to install IMAT.
5. Connect the NSU Ethernet port directly to the NIC of the PC using a
crossover cable or connect the NSU Ethernet port to the network.
Programming an IP Address into the NSU
You must change the IP and gateway addresses to match an available
address on the LAN.
Tip: IMAT is not applicable for the CX and CXi controllers.
Tip: IMAT is not needed to program Embedded PRI, T1/D4, and QSIG
(dual T1/E1 framer module or T1/E1 combo module in the controller).
Tip: You must have IMAT software version 7.3 or greater to use with Release
4.1 or greater of the 3300 ICP software. Use IMAT version 7.4 with Release
5.1 of the 3300 ICP software.
Tip: We recommend using an Ethernet connection from the IMAT PC when
running Windows NT 4.0, Windows 2000 Professional, Windows XP, or
Windows 98. For Windows 95/98 (without a NIC), use Dial-up Networking.
Tip: Refer to the IMAT online help for LAN connection details. If you're using
a dial-up connection, see “Connect a Windows 95/98 PC to the NSU via
Dial-Up” on page 90.