Programming instructions

Software Procedures

Install 6000 MAS Software

You will need this procedure only if you have to replace the Application

Processor Card (APC) hard drive. When you purchase the APC, with it’s

hard drive, the 6000 Managed Application Server (MAS) software is

already on the hard drive.

Refer to “APC Hard Drive (CXi)” on page 121 to install the hard drive.

To install the 6000 MAS software:

1. Insert the 6000 MAS software CD into a portable CD-ROM drive

attached to a USB connector located on the front panel of the 3300

ICP.

2. Power down the 3300 controller (see page 99).

3. Power up the 3300 controller.

4. Launch the secure telnet client.

- Enter open <RTC IP address> using port <2005> (command with

example IP address, open 192.168.1.2 2005).

- Enter the 3300 username and password.

5. Follow on-screen instructions to configure the 6000 MAS and blades.

Refer to the 6000 Managed Application Server documentation on Mitel

OnLine.