Programming instructions

86
3300 ICP Technician’s Handbook
Programming Overview
 Optional: use the ICP Software Installer Tool to restore a saved
database or, from 3300 Release 7.0 UR1, to migrate a database (from
SX-2000 LIGHT, SX-2000 MicroLIGHT, 3200 ICP, or 3800 WAG
systems). Prior to Release 7.0 UR1, use the 3300 Configuration Tool
to migrate a database from legacy systems. Refer to the ICP Software
Installer help system for programming information.
 Use the System Administration Tool to program the 3300 ICP. See the
System Administration Tool online help for programming information.
 Optional: Use the System Administration Tool to program networks or
clusters of 3300 ICPs. Refer to the Voice Clustering (Portable
Directory Number) Guide on Mitel OnLine for planning information.
Refer to the System Data Synchronization book in the System
Administration Tool online help for programming instructions.
 Use IMAT to program PRI/QSIG and R2 NSUs (does not apply to
Embedded T1/E1).
 Use the System Administration Tool to program the required voice
mail settings in the Voice Mail folder. Refer to the Online Help for more
information.
Basic Hardware Programming
Refer to the System Administration Tool Online Help for programming.
• “Basic Programming and Data Save” on page 25
• "Programming DHCP" on page 29
• "Programming the Controller DHCP Server Settings (for Release 7.0
and later)" on page 31
• "Configuring the Layer 2 Switch" on page 35
• "Programming the Peripheral Cabinet" on page 45
• "Programming Phones" on page 52.
Tip: These settings will not take effect until you reboot the system.
Tip: If you have not already done so, perform a DBMS Save (Step 4 on
page 26) or verify that the DBMS_Initialized flag is on (Step 5 on page 26).