Programming instructions

79
Software Procedures
Install the Software on the FTP Server
4. Refer to “Installing System Software on the FTP Server” on page 70,
Step 1 through Step 6.
Reboot the Controller
5. Launch your VT100 emulator communications program.
6. Type appShutdown, and press ENTER. The controller reboots.
7. The communication program will instruct you to Press
<SPACE><SPACE><SPACE> to stop auto-boot AFTER
countdown starts (Release 5.2 and later) or Press any key to stop
auto-boot (prior to Release 5.2). You have 7 seconds to press a key
or the system will auto-boot.
8. At [VXWorks Boot] type c, and press ENTER.
9. For each setting shown in bold (see Table 4 below), type the table
value, then press ENTER. For all other settings, press ENTER to
accept the default value.
Tip: If you miss the 10-second timeout, manually reboot the controller by
pressing the Reset button. The RTC opens, and you once again have
10 seconds to complete Step 7.
Tip: The VXWorks parameters are case-sensitive.