Programming instructions

77
Software Procedures
4. Click Configure. The Patch Definition Screen appears.
5. Click Apply Patch.
6. Specify the path of the patch source by typing a path in the text box or
clicking the Browse button and navigating to a path.
7. Choose to reboot immediately or to reboot manually later. You must
reboot your system for the patch installation to take effect.
8. Click Next to view the FTP validation dialog box. This will test the FTP
connection credentials. Click Cancel in this window to return to the
Source Definition Screen.
9. The FTP validation dialog box is displayed. Following successful
testing, the Patch Install In-Progress Screen is displayed.
Installing System Software Manually
Use this manual procedure to install software prior to Release 3.3, when a
hard drive must re replaced, or to upgrade software prior to Release
4.1.7.5. In all other cases, we recommend that you use the 3300 ICP
Software Installer Tool.
The manual upgrade/install procedure consists of the following
sub-procedures, all of which must be completed in order:
 Steps 1-2: Establish a Connection to the Controller (page 78).
 Step 3: Back up the 3300 ICP database page 78.
 Steps 5-10: Reboot the Controller (page 79).
 Steps 11-12: Set Your Purchased Mitel Options (page 81).
 Step 13: Restore the Database OR Program the System (page 81).
Time: The complete manual install procedure takes approximately 2 hours
for an average-sized database (50-100 MB) and approximately 4 hours for
a large database (600 MB), including the database restore.
CAUTION: The software install procedure will format the
controller hard drive and install new software. The
procedure will erase all system settings, including voice
mail messages, so you must back up your database. If you
do not have a database backup to restore, you will have to
reprogram the system.