Programming instructions

67
Software Procedures
Upgrade/Install Options with Cluster or Dimension
Changes
There are install/upgrade requirements to consider when dealing with
Maximum Elements per Cluster changes or Dimension Selection changes.
Tip: Before installing new 3300 ICP software, read the RN for the software
you are installing (see “3300 ICP Documentation” on page 9). Verify if any
other software/firmware components of the 3300 ICP needs to be upgraded
to work with the new software.
CAUTION: If you decrease the number of IP User Licenses
or IP Device Licenses, after saving the change, you must
perform a backup and restore.
CAUTION: You may not downgrade the CX and CXi control-
lers to a software version prior to release 6.0. A downgrade
would render the controller inoperable.
CAUTION: You may not downgrade the LX controller to a
software version prior to release 5.0. A downgrade would
render the controller inoperable.
Table 3: Maximum Elements Change or Flexed Dimension Selection
Elements / Dimensions
Software Installer
Tool
Notes
From To
Prior to Rls 6.0
with Flexed
Dimensions
Release 6.0
with Flexed
Dimensions
Install only. Do not
perform a data
restore with the SI
Tool. See “Upgrade to
Rls 6.0 or later with
Flexed Dimensions”
on page 84.
After the install is complete,
flex the dimensions, reboot,
and restore using current
dimension selections.
30 or 60 /
Flexed
Dimension
Selection
30 or 60 /
Flexed
Dimension
Selection
Install or Upgrade Use Dimension Selections
from the backup file.
(Page 1 of 2)