Programming instructions

55
Installation
12. At INPUT DNS ADDRESS, you MUST enter the IP address of the
server that will be used during Web browsing to resolve host names
into IP addresses. Skipping this field will prevent the phone from
booting. If you do not have a DNS server, enter any IP address value
(for example 10.30.32.3).
13. The following prompts are required fields for IP Appliances, optional
for multiline display sets, and do not appear for single line display sets:
INPUT WINS ADDRESS
INPUT PROXY ADDRESS
INPUT PROXY PORT
14. At USE JITTER BUFFER, enter Yes # or No *.
15. At TECHNICIAN IP ADDR?, enter the address of the debugging utility,
or leave blank.
16. At STORE IN NVRAM?, enter Yes # to store parameters in
non-volatile RAM. This step will ensure that your static setting will be
used when the set is powered-up and when the FLASH is upgraded.
17. The set will reboot and will then use the static IP data.
Removing Static IP Addresses on the IP Sets
To return to using dynamic IP addressing when static parameters were
previously enabled:
1. Plug the set cable and power into the set while holding down the
Volume Up key for 3 seconds to display the STATIC IP SETUP
MODE.
2. At the USE PRESENT SETTINGS screen, select * - DISABLE to
revert back to DHCP from static parameters.
Installing and Configuring Music on Hold
There are three types of Music on Hold available to the system,
embedded, analog, and digital.
Embedded Music on Hold is provided by audio files that are imported into
a single controller using the System Administration Tool or into multiple
controllers using Enterprise Manager.
An Embedded Music on Hold source in use consumes half an E2T
resource and each session consumes an E2T resource.