Programming instructions

Installation

1. Connect the IP device to an RJ-45 Ethernet port on the LAN. For the

CXi, connect to a controller Ethernet port.

2. Provide power to the IP device (refer to the Hardware Technical

Reference Manual at Mitel OnLine for power option information).

3. Press * during power-up (to clear any PIN number in memory).

4. Type the PIN number at the prompt on the IP device. Prompts are:

- non-display IP Phones: solid message light.

- display IP Phones and IP Appliances: display shows Enter the PIN

number.

5. Complete one of the following to send the PIN:

- 5001, 5005, 5201 and 5205 IP Phones: press Hold.

- 5010, 5207, 5215, 5020 and 5220 IP Phones: press SuperKey.

- 5140 and 5240 IP Appliances, 5235 IP Phone: press OK.

- 5230 IP Appliance: press Send.

The set will complete initialization.

The registering sequence in a cluster is unchanged provided that:

• the Cluster Element ID programmed in the Cluster Element

Assignment form matches the ICP/PBX Number programmed in the

ICP/PBX Assignment.

• each member of the cluster is programmed with the directory numbers

of the other controllers. This information must be programmed using

OPS Manager.

• the Set Registration Access Codes and Set Replacement Access

Codes are the same for each controller in the cluster.

• each IP device is able to retrieve the IP address of one of the

controllers in the cluster.

Tip: The PIN number is the set registration code followed by the set’s

extension number.