Programming instructions

45
Installation
3. Slide the peripheral switch controller card into slot 16 (see “Peripheral
Cabinet Card Layout” on page 280 for slot locations).
4. Slide the other peripheral interface cards into their appropriate slots.
5. Push the upper and lower latches away from you until they are vertical
and the cards are locked in place.
Cable the Node to the MDF
Cable the lines and trunks from the peripheral cabinet to the main
distribution frame (MDF) by using the peripheral interface cabling tables
(see “Peripheral Cabinet Cabling” on page 285).
Programming the Peripheral Cabinet
1. Power up the peripheral cabinet.
2. Using the System Administration Tool, program the peripheral cabinet.
Refer to the System Administration Tool Online Help for details.
SUPERSET HUB
Installing a SUPERSET HUB requires that you first install the peripheral
slot FIM carrier (page 45) and then the SUPERSET HUB (page 46).
Install the Peripheral Slot FIM Carrier
Tip: The CX and CXi controllers do not support SUPERSET HUBs.
WARNING: THIS PRODUCT USES A CLASS 1 LED. FIBER
OPTIC SOURCES EMIT INFRARED RADIATION. THIS
RADIATION IS INVISIBLE TO THE HUMAN EYE, AND CAN
DAMAGE THE RETINA. NEVER LOOK DIRECTLY INTO THE
END OF A FIBER OPTIC CABLE THAT YOU SUSPECT IS
ENERGIZED BY A FIBER OPTIC SOURCE. WHEN WORKING
WITH RAW FIBER OPTIC CABLES, BE AWARE OF FIBER
ENDS AND SLIVERS WHICH CAN PUNCTURE THE SKIN AND
CAUSE IRRITATION.