Programming instructions

44
3300 ICP Technician’s Handbook
2. Ensure that the switch on the power converter faceplate is set to off
(0).
3. Slide the power converter into slots 13 through 15.
4. Push the upper and lower latches away from you until they are vertical
and the power converter is locked in place.
5. Plug the internal AC power cord from the power distribution unit (PDU)
into the power converter through the access cutout in the backplane.
6. Replace the internal AC power cord access cover plate over the
access cutout in the backplane, and replace the two screws.
Installing the Peripheral Interface Cards
Refer to “Safety Considerations” on page 98.
1. Set the E&M trunk card switch settings (see page 281) and the OPS
line card message waiting switches (see page 283).
2. Check all card connector pins to be certain that they are straight.
Figure 8: Peripheral Cabinet AC Power Cord Access
CAUTION: To prevent static damage to electrical compo-
nents, ensure that the system is grounded before you install
the cards. Whenever you handle circuit cards, wear an
anti-static strap.